Free Shipping!
Seals and protects stamped concrete, decorative concrete, brick, stone and other masonry surfaces from damage and color loss while enhancing the similar to a “wet look”.
MasonrySaver® Decorative Concrete Sealer is a non-yellowing acrylic polymer blend sealer formulated for use on properly cured stamped concrete surfaces. Can be applied over both water based and solvent based sealers that have been used previously without having any adhesion issues.
Designed for use on both interior and exterior concrete, MasonrySaver® Decorative Concrete Sealer is suitable for use on a variety of surfaces where a durable gloss finish is desired including concrete patios, driveways, sidewalks and even garage floors.
Product Uses:
- Stamped Concrete
- Decorative Concrete Surfaces
- Brick Pavers
- Acid Stained Patios
- Garage Floors
- Basement Floors
Benefits:
- Can be applied over previously treated surfaces with solvent-base sealer
- Water-based formula for easy application and rapid dry time
- Provides an attractive, gloss finish to masonry and concrete surfaces
- Protects masonry and concrete surfaces from color fade
- Seals concrete surfaces making them washable and easy to maintain
- Non-yellowing, clear finish
- Durable concrete protection with “hot tire” resistance
LIMITATIONS: Not suitable for use over asphalt surfaces. This product is designed for use on horizontal or vertical surfaces. Do not use on below-grade surfaces that are subject to severe hydro-static pressures. When using in areas subjected to hot tire traffic, allow adequate time for product to cure before putting the area back into surface. When applying over previous coating, hot tire resistance maybe compromised. Do not use if the area will be exposed to softer, high performance tires. Will not “fix” old sealers or coatings that have blushed or turned milky white.
Can this be used on aggregate exposed concrete as well as our Belgard pavers we have as the pool patio coping?
It can be used on aggregate and concrete pavers.
Will it give the wet look? We are hoping the masonry saver will make it look like the wet part like in this pic.
Yes, but also look at the Super Seal 25.
https://www.opwdecks.com/25-semi-gloss.htm
I wanted the super seal but I’m in Maryland and learned from the site I can’t get it shipped to me. Is masonry saver the best alternative to this since I can’t get it here?
Use this version, it is allowed: https://www.opwdecks.com/voc-compliant.htm
Thanks and do you recommend a roller or sprayer?
I sealed the patio last Fall with the Superseal VOC and it gave a good wet look. The steps looked great too. However, the steps now look like the photo. Any thoughts?
Apply some A-100 to those steps to remove the white hazing: https://www.opwdecks.com/aromatic-100-solvent.htm
Yes this product can work on blue stone pavers. Typically is not slippery when wet after full cure.
Hi
I have a blue stone pavers that have been layed around a patio/pool area and want a sealer that will give it a wet look. Do you have anything that would suit without making it too slippery.